Is anyone getting anxious to swing some clubs?? With an early October snow storm and record fall flood, it seems like we haven’t been able to enjoy our wonderful golf course at the Grand Forks Country Club in a long time. I am trying to be as optimistic as I can with the upcoming spring thaw situation. I have my fingers crossed that the rest of February can cooperate and we don’t receive too much moisture in March.
What in the world does the superintendent do all winter??
Well, we have been very busy in the shop this winter preparing all of the equipment for the upcoming golf season. We have 38 pieces of equipment to maintain all year round. This does not include multiple string trimmers and gas powered water pumps that also need attention each year. All of these pieces of equipment are extremely important to the success of our golf course and are used heavily during the golf season by many employees.
 |
| This our our 10' cut rough mower that is currently in the shop for full service. The brakes have been inspected, tires rotated, fluids and filters changed, castor wheel bearings replaced, and machine fully cleaned. |
All of our winter equipment preparation begins the day the golf season ends. Every piece of equipment is pressure washed, brought into the heated side of our shop to fully dry and then every movable part gets greased. This prevents parts like bearings and seals from freezing from the pressure washing process and then cracking or breaking if frozen. Each individual piece is then parked in the cold side of the shop and rotated into the warm shop for a full service throughout the winter.
We change the oil and filters, hydraulic oil and filters, spark plugs, air filters, fuel filters, remove and clean the radiators, inspect brake parts, replace any worn or broken parts, and touch up paint where needed.
 |
| The above two photos are from the rear axle of our other 10' cut rough mower. We found a broken bearing and leaking seal in the rear axle that needed to be replaced before more damage occurred in the axle. |
We have 23 reels and bedknives that complete all of the cutting on our low mowed turfgrass. Each reel comes off of the mower and needs to be inspected and sharpened on our reel grinding machines.
 |
| Here is a photo of our fairway mower reels. Each one is taken apart for inspection and sharpening. |
I have been extremely fortunate during my time at the GFCC for the commitment of replacing old equipment on a financially responsible time frame. There gets to be a time where the parts and work that a machine needs gets to be more expensive than what the machine is worth. Although it is still typically less expensive to fix equipment rather than to purchase new, some of these pieces of equipment are broken down in the shop more often than running out on the golf course. I believe we have done an excellent job replacing those few pieces of equipment that fall into that category.
Other than equipment maintenance, we are busy in the shop rebuilding, painting, and staining course accessories. Last winter we were able to build new tee markers for the golf course. By building our own tee markers, we saved roughly $3,000 and only spent $300 with the tee marker design that we chose. Anything that we are able to build in-house usually saves us large amounts of money.
In addition to maintenance, I typically get to attend a few turfgrass educational opportunities in the area. These opportunities are excellent for keeping a fresh mind for maintaining a golf course, new ideas to improve course conditions, and networking with other turfgrass professionals all over our tri-state region. One other exciting opportunity that I get to be a part of this winter is the Master Planning process for the Grand Forks Country Club provided by Herfort Norby Architects. With a plan in place, the future of the GFCC is very exciting. Stay tuned for updates!
Lastly, he may only be 6 weeks old, but I see this guy on a greens mower in the future!
Meet Everet Cannon
